Machines / CV-3PO

CV-3PO

Four channels of control voltage, each one set by hand on its own slider.

CV-3PO seen from the front: four sockets on top, four slide pots, two buttons and the LEDs below
4CV outputs
12-bitDAC
3voltage modes
10 sof recorded moves

CV-3PO is a Eurorack module with four channels of control voltage, each set by its own slide pot. Step through pitch sequences, sweep a filter or hold a steady voltage in your modular rig.

An LED on every channel shows what it sends. Press record, move the sliders, and CV-3PO plays your moves back on a loop.

Each channel switches between 0–5V, 0–10V and ±5V, so it fits the rest of your rig. Calibration per channel and a 12-bit DAC keep every voltage accurate.

Four sliders, two buttons and six LEDs: everything you need sits under your hand.

CV-3PO in a Eurorack case, its sliders lit
Close-up of the four lit slider caps
CV-3PO patched, with cables in the sockets above the sliders

How it plays

Three voltage modes per channel

Switch freely between 0–5V, 0–10V and ±5V bipolar output on each of the four independent channels.

Record and play back

Record your slider moves at 20 Hz and play them back on a loop. A steady voltage becomes a moving sequence.

12-bit, calibrated per channel

The DAC and per-channel calibration tables keep the output accurate and repeatable in every mode.

Every control under your hand

Four slide pots, two buttons and LED feedback. Every move changes the voltage at once.

Specifications

Processing
ProcessorATmega4809 (@ 20 MHz)
DACMCP4728, 4-channel, 12-bit
Output
Voltage modes0–5V unipolar, 0–10V unipolar, ±5V bipolar
Channels4 independent analog CV outputs
Interface
Controls4 slide potentiometers (10-bit ADC input)
Buttons2 tactile buttons (left/right) with debounce
ResetDedicated analog threshold reset input
LEDs6 in total: 4 channel indicators (PWM) and 2 button status
System
Switching4 relay-driven digital outputs
ConnectivityI2C (SDA/SCL) for DAC communication
State storageEEPROM: keeps the channel modes through power cycles
Recording4-channel potentiometer recorder, 20 Hz sample rate (about 10 seconds in total)
CalibrationPer-channel, per-mode DAC margin calibration and an LED brightness curve

A question about CV-3PO, or an idea for it? Send an email.